Running KhiCAS in exam mode
===========================
Beware that it is the user responsability to ensure that CAS is allowed during exam.

Open KhiCAS shell, either run khicas.tns or from khicaslua.tns type * enter.
Type the calculator key (between esc and tab) then the e^x key, or Home ctrl e^x e^x on monochrom Nspire.
KhiCAS will check all files in the ndless directory and copy the required ressources
in the exam directory mode. This take some time, you can accelerate it by keeping
only one khicas.tns or luagiac.luax.tns and by deleting ressource files that do not
correspond to your OS (note that on nspire monochrom, due to low flash size, only the calling program will be copied). Once the copy is finished, the calculator reboots in exam mode.
You will have to activate ndless, then you can run KhiCAS. The whole process takes up
to 2 minutes.

If you need to reactivate exam mode: from KhiCAS shell, press the calculator key then e^x key
and confirm (or home ctrl e^x e^x on monochrom Nspire). KhiCAS will clear all files in the exam mode directory except the ressources
required to run KhiCAS.
On the CX2, the LEDs are set to off. You are left in restricted mode, no
save, no load. Leaving KhiCAS will reboot the calculator and restart the LEDs.
On other models, the calculator is reset immediatly.

Warning:
========
If you run OFF then Esc-ON then Reinit exam mode, this will not keep the ressources
required to run KhiCAS. Educational institutions that forbid CAS in exam might ask
their students to reinitialize pure TI exam mode that way.