Not loading configuration when started with fiename on command line
Publié : mar. oct. 31, 2023 11:53 pm
xcas 1.9.0-66 (c) 2000-18, Bernard Parisse, Renee De Graeve
When I start xcas with a file on the commandline:
$XCAS_ROOT/xcas.exe "$(pwd)/eq_funcs.xws" "$@"
from a modified runxcas.en the Bandeau and other items at the bottom are not there. Any filename on the command line seems to cause this behavior. Turning them on and saving the config does not make them come up the next time I start xcas. This used to work, but I can't remember how many versions back that was. The stock works fine, the items appear as they should, however they were when I saved configuration in the cfg menu.
By the way, is the configuration saved in the xws file? That might cause it.
Thanks
Matt
When I start xcas with a file on the commandline:
$XCAS_ROOT/xcas.exe "$(pwd)/eq_funcs.xws" "$@"
from a modified runxcas.en the Bandeau and other items at the bottom are not there. Any filename on the command line seems to cause this behavior. Turning them on and saving the config does not make them come up the next time I start xcas. This used to work, but I can't remember how many versions back that was. The stock works fine, the items appear as they should, however they were when I saved configuration in the cfg menu.
By the way, is the configuration saved in the xws file? That might cause it.
Thanks
Matt